The following lines were added (+) and removed (-):
== Controls ==#Mode Selector - Selects CW, AM, FM, USB, or LSB.#SWR CAL - Adjust the calibration of the SWR meter wile in the SWR CAL mode.#RIT Control - The Receiver Incremental Tuning control match your xmit freq with rec freq. Very sensitive.#RF Gain Control. - Varies the RF input to the receiver and helps eliminate strong, adjacent signals.#Mic Gain. - Selects a lower Mic gain level. More gain is preferable unless distortion occurs.#TX Switch - Locks the transmitter in the on position. This should be glued so it cannot be pressed.#Meter Switch - Selects either RF/S, MOD, SWR CAL, or SWR.#PA Switch - Selects the PA Mode if an external PA speaker is connected. Useless.#NB Switch - Helps eliminate interference generated by vehicle ignition systems.#Dim Switch - Selects the level of the backlight of the display.#Scan Control - Used to scan up to 50 channels in each band segment.#Span Control - Select 10 KHz, 1 KHz, or 100 Hz steps for the VFO.#Channel UP/DOWN- Step up or down to the next 10 KHz channel in the currently selected band segment.#Roger Beep- beep tone when you release the PTT switch. Should never be used, HAM ops dislike.#Band Control - Selects one of four bands.#F. Lock - Disables all frequency controls [except RIT] to prevent accidental changes of frequency.#VFO Control - Digital Variable Frequency Oscillator control used to select the desired frequency.#Squelch - Squelch weak and unwanted signal noise.#Volume Control - Turns the unit on or off and adjusts the volume.== External Resources ==