The following lines were added (+) and removed (-):
Disable seat-belt alarm#Turn the ignition switch to the OFF position, and buckle the driver’s seat belt.#Turn the ignition key to the ACCESSORY/RUN position (engine does not need to be running), and wait for the Seat Belt Warning Light to turn off.#Within 60 seconds of starting the vehicle, unbuckle and then re-buckle the driver’s seat belt at least three times within 10 seconds, ending with the seat belt buckled.#Turn the ignition key to the OFF position. A single chime will sound to signify that you have successfully completed the programming.The Enhanced Warning System (BeltAlert) can be reactivated by repeating this procedure.The important steps are:* DO NOT START THE JEEP.* Get in* Buckle-up* Turn the key to ACC on.* Once the seat belt dummy light goes out, unbuckle and buckle 3 or more times.* Turn off and remove the key. You should hear a confirmation tone.