View source for Midland Model 13-857 CB Radio

From Free Knowledge Base- The DUCK Project: information for everyone

← Midland Model 13-857 CB Radio

You do not have permission to edit this page, for the following reason:

---

You can view and copy the source of this page:

Midland 13-857 CB Radio This was a black and silver CB radio with front dials with squelch and delta knobs, attached cord to walkie. wires attached to back. The start date of manufacture was 1976, *frequency Range: 26.965-27.255 MHz *channels: 23 *mode: AM *xmit power: 4 W *frequency control: XTAL-synthesis *voltage: 13.8 VDC *period: 1970s *size: radio L: 7.5" H: 2.5" D: 9.5" walkie L: 3" H: 4" D: 2" cord 1'5" [[File:midlandmodel13857sm.jpg]] Variations: * Model 13-857 * Model 13-857B * Model 77-857 The model 77-857 was a 40 channel version of the original 23 channel 13-857. Advertisement from 1976 [[File:midlandscbad1976big.gif]] ==Specification== These Midland radios were Cybernet board based radios with the PLL02A phase-locked loop circuit and three crystals. ==Service== ===Microphone Wiring=== PIN FUNCTION 1 audio 2 ground / common 3 receive 4 PTT ==Modification== Adjustments chart: Model AM Power SSB Power Modulation ------------------------------------------------------------------- 13-857 L8,L9 ¾ RV2 or Cut D10 13-857B L110,L109 ¾ RV102 or Cut D111 77-857 L7,L11,L12 ¾ RV2 or Remove C96 ------------------------------------------------------------------- ===Modulation Adjustment RV2=== Tune the following coils with maxium with a 1000 Hz tone injected through the microphone and using a peak reading wattmeter on channel 13: L7, L8, (L9 is a TVI filter - tune for minimum interference on TV.) New channels can be obtained either by switching X11 and X12 or by substituting other crystals for them. X11 = 11.730 receive oscillator X12 = 11.275 transmit oscillator ------ .455 As you can see, X11 is 455 KC higher than X12. This is how you get your receive IF frequency of 455 KC. If you swap X11 and X12 around, you will get low channels. This can be done easily by using a switch. Be sure to use solid hookup wire between the switch and board. Keep the leads as short as possible. The wiring configuration should look like what is showed in the following diagram. [[File:CBMidlandlowchannels.gif]] *S1 use a DPDT toggle switch If you use other crystals, they must be 455 KC apart so receive and transmit will work together correctly. [[Category:Electronics]] [[Category:Radio]] [[Category:Tangible Product]] [[Category:2-Way Radio]] [[Category:CB Radio]]

Return to Midland Model 13-857 CB Radio.