Difference between revisions of "Common mode noise"
From Free Knowledge Base- The DUCK Project: information for everyone
(Created page with "Common-mode currents are detrimental to antenna system efficiency, noise or unwanted signal ingress, and/or pattern. Common mode currents: * in verticals with sparse c...") |
|||
| (One intermediate revision by one user not shown) | |||
| Line 5: | Line 5: | ||
* in receiving systems increase noise floor | * in receiving systems increase noise floor | ||
* in all antenna systems can alter antenna pattern, especially in nulls | * in all antenna systems can alter antenna pattern, especially in nulls | ||
| + | |||
| + | If common mode currents are significant enough to alter patterns, common mode currents can also transfer unwanted signals and noise into our transmitting antennas when receiving. | ||
| + | |||
| + | Sleeve baluns or snap on baluns are normally used at VHF and higher. They are often not practical at HF. | ||
| + | |||
| + | [[Category:Electronics]] | ||
| + | [[Category:Radio]] | ||
| + | [[Category:Ham Radio]] | ||
Latest revision as of 23:13, 22 March 2016
Common-mode currents are detrimental to antenna system efficiency, noise or unwanted signal ingress, and/or pattern. Common mode currents:
- in verticals with sparse counterpoise systems negatively impact system efficiency
- in all transmitting antennas can increase local RFI
- in receiving systems increase noise floor
- in all antenna systems can alter antenna pattern, especially in nulls
If common mode currents are significant enough to alter patterns, common mode currents can also transfer unwanted signals and noise into our transmitting antennas when receiving.
Sleeve baluns or snap on baluns are normally used at VHF and higher. They are often not practical at HF.
