Difference between revisions of "Kenwood TM-241A"
From Free Knowledge Base- The DUCK Project: information for everyone
m (→Programming) |
|||
| Line 15: | Line 15: | ||
# Select the memory channel to store the frequency in. | # Select the memory channel to store the frequency in. | ||
# Press the [MR/M] button within 10 seconds. If you hear a long beep, and the F indicator and channel indicator go away then the program was successful. | # Press the [MR/M] button within 10 seconds. If you hear a long beep, and the F indicator and channel indicator go away then the program was successful. | ||
| + | |||
| + | |||
| + | [[Category:Electronics]] | ||
| + | [[Category:Radio]] | ||
| + | [[Category:Ham Radio]] | ||
| + | [[Category:2-Way Radio]] | ||
| + | [[Category:Tangible Product]] | ||
| + | [[Category:Transceiver]] | ||
Revision as of 21:11, 10 September 2018
VFO Control
Select CTCSS Tone
- Long-press the F key. The F indicator will flash.
- Press the TONE/T.ALT button
- Turn dial to select PL tone.
- Once correct tone selected, short-press F key to accept.
Programming
- Press the [VFO] key to select the VFO operating mode
- Select the frequency, tone, offset
- Press the [F] key. The [F] indicator and a channel memory number will be displayed.
- Select the memory channel to store the frequency in.
- Press the [MR/M] button within 10 seconds. If you hear a long beep, and the F indicator and channel indicator go away then the program was successful.
