Difference between revisions of "Icom IC-7600"
From Free Knowledge Base- The DUCK Project: information for everyone
Line 21: | Line 21: | ||
*AM Maximum Power: 30 W | *AM Maximum Power: 30 W | ||
*AM Minimum Power: 1 W | *AM Minimum Power: 1 W | ||
+ | |||
+ | ==Ver.2.00 Firmware== | ||
+ | [[File:icomic7600firmwareup01.jpg]] | ||
+ | |||
+ | Tip: The first time you update, thoroughly read the Section 14 (UPDATING THE FIRMWARE) of the IC-7600’s instruction manual and information for firmware 2.00 on Icom Co. Support page. The firmware can be updated using a USB-flash drive. | ||
+ | |||
+ | Some new features: | ||
+ | *point and click the mouse for Click-and-Listen receiver control. | ||
+ | |||
+ | [[File:icomic7600firmwareup02.jpg]] | ||
+ | |||
Revision as of 20:56, 17 October 2017
The Icom IC-7600 covers the 160 to 6 meter amateur bands. It utilizes IF-DSP technology and selectable roofing filters at 3kHz, 6kHz and 15kHz. Like the IC-7700 and IC-7800, the IC-7600 uses dual 32-bit floating-point Texas Instruments DSP chips with one for the radio and the other for the spectrum scope. This display is a 5.8 inch color WQVGA LCD.
Status: Currently on the market as of 2017, still in production. Replaces the Icom IC-756 Family of transceivers.
- Receive Range 1: 0.030-60.000 MHz
- Receive System: Single receiver
- Dual Watch: Yes
- Roofing Filter Capability: Yes
- Roofing Filter Bandwidth: 15/6/3kHz
- Third Order Intercept (IP3): Over 30 dBm
- Transceiver Input Voltage: 13.8 Vdc
- Transceiver Maximum Current: 23.0 A
- Antenna Ports: 2
- Computer Connection Type: USB or CI-V interface
- Digital Mode Audio Input/Output: USB or 8-pin DIN
- Voice Synthesizer Capability: Yes
- Radio Dimensions: Width 13.375", Height 4.563", Depth: 11.000"
- Weight: 22.000 lbs.
- SSB/CW Maximum Power: 100 W
- SSB/CW Minimum Power: 2 W
- AM Maximum Power: 30 W
- AM Minimum Power: 1 W
Ver.2.00 Firmware
Tip: The first time you update, thoroughly read the Section 14 (UPDATING THE FIRMWARE) of the IC-7600’s instruction manual and information for firmware 2.00 on Icom Co. Support page. The firmware can be updated using a USB-flash drive.
Some new features:
- point and click the mouse for Click-and-Listen receiver control.