Difference between revisions of "Kenwood TM-241A"
From Free Knowledge Base- The DUCK Project: information for everyone
m |
|||
| Line 1: | Line 1: | ||
| + | *Frequency Range TX: 144 - 148 MHz | ||
| + | *RX: 118 - 174 MHz | ||
| + | *RF Output Power HI 50 W | ||
| + | *RF Output Power LO 5 W | ||
| + | *RF Output Power MID 10 W | ||
| + | *Power Requirement 13.8V DC (±15%) | ||
| + | *Current Drain Receive Less than 600 mA | ||
| + | *Current Drain Transmit Less than 11 Amps | ||
| + | *Microphone Impedance 500-600 ohms | ||
| + | *Antenna Impedance 50 ohms | ||
| + | *Dimensions (W x H x D) 5.51 x 6.3 x 1.57 in. (140 x 40 x 160 mm) | ||
| + | *Weight (approx.) 2.4 lbs. (1.1 kg) | ||
== VFO Control == | == VFO Control == | ||
Revision as of 13:17, 1 February 2019
- Frequency Range TX: 144 - 148 MHz
- RX: 118 - 174 MHz
- RF Output Power HI 50 W
- RF Output Power LO 5 W
- RF Output Power MID 10 W
- Power Requirement 13.8V DC (±15%)
- Current Drain Receive Less than 600 mA
- Current Drain Transmit Less than 11 Amps
- Microphone Impedance 500-600 ohms
- Antenna Impedance 50 ohms
- Dimensions (W x H x D) 5.51 x 6.3 x 1.57 in. (140 x 40 x 160 mm)
- Weight (approx.) 2.4 lbs. (1.1 kg)
VFO Control
Select CTCSS Tone
- Long-press the F key. The F indicator will flash.
- Press the TONE/T.ALT button
- Turn dial to select PL tone.
- Once correct tone selected, short-press F key to accept.
Programming
- Press the [VFO] key to select the VFO operating mode
- Select the frequency, tone, offset
- Press the [F] key. The [F] indicator and a channel memory number will be displayed.
- Select the memory channel to store the frequency in.
- Press the [MR/M] button within 10 seconds. If you hear a long beep, and the F indicator and channel indicator go away then the program was successful.
