2009 Jeep Wrangler JK: Difference between revisions

Revision as of 10:00, 29 August 2016

Disable seat-belt alarm

Turn the ignition switch to the OFF position, and buckle the driver’s seat belt.
Turn the ignition key to the ACCESSORY/RUN position (engine does not need to be running), and wait for the Seat Belt Warning Light to turn off.
Within 60 seconds of starting the vehicle, unbuckle and then re-buckle the driver’s seat belt at least three times within 10 seconds, ending with the seat belt buckled.
Turn the ignition key to the OFF position. A single chime will sound to signify that you have successfully completed the programming.

The Enhanced Warning System (BeltAlert) can be reactivated by repeating this procedure.

The important steps are:

@@ Line 4: / Line 4: @@
 *Horsepower: 202 hp
 *Other model years: 2007, 2008, 2010, 2011
+Disable seat-belt alarm
+#Turn the ignition switch to the OFF position, and buckle the driver’s seat belt.
+#Turn the ignition key to the ACCESSORY/RUN position (engine does not need to be running), and wait for the Seat Belt Warning Light to turn off.
+#Within 60 seconds of starting the vehicle, unbuckle and then re-buckle the driver’s seat belt at least three times within 10 seconds, ending with the seat belt buckled.
+#Turn the ignition key to the OFF position. A single chime will sound to signify that you have successfully completed the programming.
+The Enhanced Warning System (BeltAlert) can be reactivated by repeating this procedure.
+The important steps are:
+* DO NOT START THE JEEP.
+* Get in
+* Buckle-up
+* Turn the key to ACC on.
+* Once the seat belt dummy light goes out, unbuckle and buckle 3 or more times.
+* Turn off and remove the key. You should hear a confirmation tone.
 &nbsp;