Difference between revisions of "Icom IC-7600"

Revision as of 20:56, 17 October 2017

The Icom IC-7600 covers the 160 to 6 meter amateur bands. It utilizes IF-DSP technology and selectable roofing filters at 3kHz, 6kHz and 15kHz. Like the IC-7700 and IC-7800, the IC-7600 uses dual 32-bit floating-point Texas Instruments DSP chips with one for the radio and the other for the spectrum scope. This display is a 5.8 inch color WQVGA LCD.

Status: Currently on the market as of 2017, still in production. Replaces the Icom IC-756 Family of transceivers.

• Receive Range 1: 0.030-60.000 MHz
• Receive System: Single receiver
• Dual Watch: Yes
• Roofing Filter Capability: Yes
• Roofing Filter Bandwidth: 15/6/3kHz
• Third Order Intercept (IP3): Over 30 dBm
• Transceiver Input Voltage: 13.8 Vdc
• Transceiver Maximum Current: 23.0 A
• Antenna Ports: 2
• Computer Connection Type: USB or CI-V interface
• Digital Mode Audio Input/Output: USB or 8-pin DIN
• Voice Synthesizer Capability: Yes
• Radio Dimensions: Width 13.375", Height 4.563", Depth: 11.000"
• Weight: 22.000 lbs.
• SSB/CW Maximum Power: 100 W
• SSB/CW Minimum Power: 2 W
• AM Maximum Power: 30 W
• AM Minimum Power: 1 W

Ver.2.00 Firmware

Tip: The first time you update, thoroughly read the Section 14 (UPDATING THE FIRMWARE) of the IC-7600’s instruction manual and information for firmware 2.00 on Icom Co. Support page. The firmware can be updated using a USB-flash drive.

Some new features:

• point and click the mouse for Click-and-Listen receiver control.