Difference between revisions of "Mouse Sensitivity in Linux"

Revision as of 13:19, 3 November 2020

Whether you are talking about mouse speed, sensitivity, or acceleration in linux, adjustment is often difficult.

Mouse is very sensitive in most systems with wireless mouse. The mouse pointer sensitivity is too high and the controls in System Settings don't give the user enough control to reduce it to a useable level. The "Sensitivity" setting seems to do almost nothing. It used to be labeled "Threshold" and it seems to act in reverse of what you might be trying to accomplish.

In working with Linux for over 20 years now it still seems as though the developers pay little attention to quality mouse control applets and utilities. It seems to be hit and miss, and while I appreciate the open source nature of Linux, this has to be one of the biggest hindrances towards wide spread acceptance of this operating system when it is so difficult to tame the average mouse pointing device.

The suggestions below are useful for experimentation. As the old cliche goes, your actual mileage may vary.

xinput method

This works in newer Mint and Ubuntu distributions.

When you type

 xinput --list --short

There will be a lot of output on the screen and more than one mention of a mouse in the list. It is recommended you run this command with the mouse connected, then again with the mouse disconnected. Note the change. Whichever was absent when the mouse was disconnected will likely be your mouse.

In a test example we noted that "PixArt Gaming Mouse" with an id=8 was only visible in the output of xinput --list --short when the mouse was connected. Looks like:

 ↳ PixArt Gaming Mouse                     	id=8	[slave  pointer  (2)]

With this information there are some different tricks to taming the mouse.

It was said on linuxmint.com that "You may have to play around with the values. Constant Deceleration of 1 is very slow, 9 is very fast."

The following command example utilizes the ID of the mouse

xinput set-prop 8 "Device Accel Constant Deceleration" 3
# 8 = DEVICE_ID
# 3 = LEVEL (factor) Higher = Slower.

The following command examples utilize the NAME of the mouse rather than the ID.

xinput --set-prop "PixArt Gaming Mouse" "Device Accel Constant Deceleration" 2
xinput --set-prop "PixArt Gaming Mouse" "Device Accel Velocity Scaling" 1
xinput --set-prop "PixArt Gaming Mouse" "Device Accel Profile" -1

To make the config persistent (and make it system wide), you will need to edit your xorg.conf (/etc/X11/xorg.conf).

Section "InputClass"
  Identifier      "Razer"                    # Whatever you want.
  MatchProduct    "Razer Razer DeathAdder"   # Product name from xinput list.
  Option          "ConstantDeceleration" "3" # The same value as xinput.
EndSection

xset method

Find the initial setting

xset -q | grep accel

Modify the acceleration

xset m 1/3

or

xset m 4/10

or

xset m 1/2 4

Try a fract ion that works for you

To reset default values:

xset m default

Edit ~/.config/autostart/mouse.desktop to make changes stick