Dentron MT-2000A and MT-3000A

From Free Knowledge Base- The DUCK Project: information for everyone
Revision as of 18:29, 2 March 2017 by Ke0etz (Talk | contribs)

Jump to: navigation, search

These are efficient antenna tuners capable of handling full legal limit power for use with amateur radio.

  • Freq Coverage: 1.8 MHz - 30 MHz continuous
  • Power Handle: 3000 watts P.E.P.

You should connect only one antenna at a time to the MT-2000A. The MT-3000A will accommodate multiple simultaneous connected antennas.

Although you can physically connect an antenna via the PL-239 and another antenna via the balanced line connector to the MT-2000A, you should not do this as there is no way to select between them from the unit and consequently you will have problems.

Inductor Guide

Inductor selection is a starting point for you to tune to resonance with your own antenna setup.

Dentron recommends setting both capacitor selectors (Transmitter Matching) and (Antenna matching) to setting 5 before trying to locate the correct inductor setting for the frequency. Watch for the highest noise/signal level on the S meter. When the best inductor is located then fine tune using the capacitance tuning dials. If tuning for the higher bands 20, 15 and 10 set the "transmitter" capacitance to 8 instead of 5.

(A) on the inductor is the highest frequency and (R) is the lowest frequency on the inductor switch.

The following guide is for an Inverted V 66½' on each leg @ 45degrees for 75-meter

band       frequency    inductor      cap and ind select
-----------------------------------------------------------
160          1990          R          6.7, R, 5.0
 80          3980          K          4.0, K, 3.0          1:1
 60
 40
 20
 15
 10
-----------------------------------------------------------