The TIA/EIA 568-A standard which was ratified in 1995, was replaced by the TIA/EIA 568-B standard in 2002 and has been updated since. Both standards define the T-568A and T-568B pin-outs for using Unshielded Twisted Pair cable and RJ-45 connectors for Ethernet connectivity.
TWISTED PAIR ETHERNET WITH RJ-45 CONNECTOR
If you hold the RJ-45 connector facing you (as if you were going to plug it into your mouth) with the lock tab down, then the pins are numbered 1 to 8 from left to right. The pin usage is as follows:
Pin Number Assignment
---------- ----------
1 Output Data (+)
2 Output Data (-)
3 Input Data (+)
4 Reserved for Telephone use
5 Reserved for Telephone use
6 Input Data (-)
7 Reserved for Telephone use
8 Reserved for Telephone use
CLIP FACING DOWN - This is how I wire the connector on twisted pair ethernet: Three (3) and six (6) must be a twisted pair.
T568B RJ 45 Std Cross Over Cable T568A RJ 45 (less common) --------------- --------------- --------------- 1. White Orange 1. White Green 1. White Green 2. Orange 2. Green 2. Green 3. White Green (twisted pair) 3. White Orange 3. White Orange (twisted pair) 4. Blue 4. White Brown 4. Blue 5. White Blue 5. Brown 5. White Blue 6. Green (twisted pair) 6. Orange 6. Orange (twisted pair) 7. White Brown 7. Blue 7. White Brown 8. Brown 8. White Blue 8. Brown
- A Standard T568A or T568B cable are identical on both ends.
- Standard T568A or T568B cables are often used as "patch cords."
- A crossover cable is used to connect two network devices in the absence of a network hub.
- The crossover cable basically switches the orange and green wire sets.
- Never untwist more than ½ of the tiny wires to reduce any occurrence of crosstalk.
- Kinks in the network cable, or running the cable near devices that produce RF noise may negatively impact network performance.
- The blue and brown wire pairs on pins 4, 5, 7, and 8 are not used in either standard.
- Do not exceed 330ft in a single cable run for 100BaseTX fast Ethernet.
- Do not exceed 980ft in a single cable run for 10baseT Ethernet.
Ironically, the wires on pins 4, 5, 7, and 8 could be cut and completely omitted from the connectors. They are not used in 10BaseT or 100Base-TX.