Sonicview SV-360 Premier

SVLan Setup

Menu Load Method

Part 1

1. Download and unzip latest bin to your USB drive
2. With power off, insert USB drive into USB front port on receiver
3. Open Menu, navigate to PVR Options, Front USB, and select the bin file from the list
4. Choose S/W Update. Wait while file loads and updates, be patient, do not disturb receiver or thumb drive
5. Reboot Yes when prompted

Part 2

1. Download and install Wiznet 3.0.1 to your PC (you need this or latest version)
2. With Sonicview on, and SVLan connected, goto PC and run Wiznet
3. PC and SVLan on receiver must both be connected to same LAN switch or hub
4. In Wiznet choose "Search" and it will find your SVLan adapter via network and show the Mac Address
5. Use Wiznet to set the IP address for SVLan (network settings appropriate for your LAN)
6. Once set click the "Settings" button next to the "Search" button

Part 3 (Skip if you see the Network Connected Message)

1. This step resolves SVLan network device related error
2. You may need to download and install Premier_svlan_special_99 (place bin on USB drive)
3. Goto Sonicview and load this bin, which will make the SVLan work (if you were getting a network error before)

Part 4

1. Press Menu; Choose System Settings; Choose Time Settings; Choose your time zone exit.
2. Press Menu; Choose System Settings; Choose User Options; Set all to ON Choose your local and exit.
3. Press Menu; Choose System Settings; Choose Parental Conrol; 0000; Set all to OFF, and ACC to Disable.

Part 5

1. Set up birds and scan for channels

Part 6

1. Enter "Serial Numnber" for SVLan

Force Load Method

How To Force Load Sonicview SV-360 Premier With USB Drive

1. Turn the the Premier Off completely from the rear power switch
2. Format USB flash drive
3. Copy latest bin file fix to the flash drive
4. Insert flash drive into premier usb port
5. Press and hold Ok button (located on the front panel) and then turn the Premier On using the rear power switch
6. Select the bin file and let it load

Channel Setup

Charlie Testing Setup

Note: the following is theoretical, do not actually attempt this.

first load the newest channel template file

then scan sats in this order:

Tuner

 Echostar 7(119W)
 Changed LNB type to OSC-DP
 Changed Transponder to 12239
 Changed Diseqc to Port 1

• Selected Blind Scan
• Saved scan when done

Tuner

 Echostar 8 (110W)
 Changed LNB type to OSC-DP
 Changed Diseqc to Port 2

• Selected Blind Scan
• Saved scan when done

Support

• (FTAforall-Receiver-Discussion) Forum section dedicated to this receiver. These guys are real forum nazis so make sure you format your post perfectly.
• (MyFreeNeeds-Sonicview360P-Discussion) Another forum section where this receiver is discussed.

Network Adapter Error!!! 
Please switch on again!!!