Difference between revisions of "Pantech Breakout"

From Free Knowledge Base- The DUCK Project: information for everyone
Jump to: navigation, search
(Enable USB Debugging)
Line 59: Line 59:
 
=== Enable USB Debugging ===
 
=== Enable USB Debugging ===
  
 +
# Select Settings.
 
# Select Applications.
 
# Select Applications.
 
# Select Development.
 
# Select Development.

Revision as of 10:55, 9 April 2013

Pantech Breakout387.jpg

The Pantech Breakout runs on Verizon's 4G LTE network. Android 2.3 Gingerbread with Pantech's custom UI. This is Pantech's first CDMA smartphone. It has a 5 MP Rear Camera & VGA Front Camera
, but no flash. The Breakout is a dual-band EV-DO Rev A (850/1900 MHz) and 750 MHz 4G LTE device with 802.11b/g/n Wi-Fi. Verizon says to expect download speeds around 5 to 12 Mbps, and upload speeds between 2 and 5 Mbps on its 4G network. You can also use the Breakout as a mobile hotspot to provide a Wi-Fi connection for up to 10 devices.

Pantech Breakout on Pantech USA.

Review

Fast 4G speeds. Solid performance. Terrific talk time. Relatively inexpensive.

Below-average camera.

PC Magazine calls the Pantech Breakout, "your best choice for achieving 4G LTE speeds on a budget."

Personalization

Root

See Here it is the easiest root and recovery method out there!! on Phandroid.

This can root, unroot, install stock recovery, and install CWM recovery.

How do I install this? CWM or Stock Recovery

  1. Download the .zip
  2. Extract zip to desktop
  3. Make sure all drivers are installed (Fastboot drivers are included)
  4. On phone, enable USB Debugging
  5. Connect phone to computer and enable USB Mass Storage
  6. Run RecoveryAIO.bat
  7. Make your selection (1-CWM & 2-Stock)
  8. Watch the magic!!!

Root

  1. After CWM installs pull battery
  2. Immediately hold Search & Power through Pantech splash screen (If the phone boots, you will lose recovery and have to start the process all over again.)
  3. Flash BreakoutRoot.zip
  4. Reboot

Unroot

  1. Reboot into recovery
  2. Flash BreakoutUnroot.zip
  3. Reboot
  4. Run RecoveryAIO.bat

Buttons The button layout for CWM is volume rocker for up and down, camera button selects, and back button goes back

Downloads Recovery All in One

Breakout Root Zip

Breakout Unroot Zip

Enable USB Debugging

  1. Select Settings.
  2. Select Applications.
  3. Select Development.
  4. Select USB debugging.

Support

Resources