Difference between revisions of "Block SMTP Authentication Attacks With Fail2Ban"

Revision as of 15:07, 7 February 2014

Blocking SMTP authentication brute force attacks using Fail2Ban - Fail2Ban can be used to block brute force attacks against your mail server. The attackers are blocked by their source IP using iptables. Although it doesn't block SMTP attacks by default, Fail2Ban can be configured to do so.

Fail2ban works by scanning log files to detect attacks such as log entries indicating multiple failed login attempts. It scans though the log, identifies an offending IP address, then creates an on-the-fly firewall rule to block it. It is typically configured to use iptables to accomplish this, however, it is not restricted to any one firwall, or using just firewall rules.

obtain and install

First, you need to install Fail2Ban. For Redhat/Fedora use yum.

yum install fail2ban

CentOS: fail2ban is not available from CentOS. It will have to be manually downloaded. You can get it from EPEL, the Fedora repository.

 wget http://mirror.pnl.gov/epel//6/i386/fail2ban-0.8.11-2.el6.noarch.rpm
 rpm -ih --percent fail2ban-0.8.11-2.el6.noarch.rpm

You might have some dependencies to install, like

 yum install gamin-python
 wget http://mirror.pnl.gov/epel//6/i386/python-inotify-0.9.1-1.el6.noarch.rpm
 rpm -ih --percent python-inotify-0.9.1-1.el6.noarch.rpm

These are the most common 2 needed for CentOS users. Get them and any others possibly needed then try to install fail2ban again. Additional help is available for RPM Commands.

ALL LINUX DISTRIBUTIONS - Fail2ban is written in Python, thus no compilation is required. You can even run Fail2ban without installing it. It can always be obtained directly from http://www.fail2ban.org

configure

jail.conf / jail.local

Comments in jail.conf clearly warn against modifications in jail.conf. Put your customizations in a jail.local file or a jail.d/customisation.local

 cp /etc/fail2ban/jail.conf /etc/fail2ban/jail.local
 vi /etc/fail2ban/jail.local

Important Configuration Parameters:

• ignoreip: This is a space-separated list of IP addresses that cannot be blocked by fail2ban.
• bantime: Time in seconds that a host is blocked if it was caught by fail2ban (600 seconds = 10 minutes).
• maxretry: Max. number of failed login attempts before a host is blocked by fail2ban.
• filter: Refers to the appropriate filter file in "/etc/fail2ban/filter.d".
• logpath: The log file that fail2ban checks for failed login attempts.