Difference between revisions of "Dentron MT-2000A and MT-3000A"
From Free Knowledge Base- The DUCK Project: information for everyone
(→Inductor Guide) |
m |
||
| Line 6: | Line 6: | ||
Dentron recommends setting both capacitor selectors (Transmitter Matching) and (Antenna matching) to setting 5 before trying to locate the correct inductor setting for the frequency. Watch for the highest noise/signal level on the S meter. When the best inductor is located then fine tune using the capacitance tuning dials. | Dentron recommends setting both capacitor selectors (Transmitter Matching) and (Antenna matching) to setting 5 before trying to locate the correct inductor setting for the frequency. Watch for the highest noise/signal level on the S meter. When the best inductor is located then fine tune using the capacitance tuning dials. | ||
| − | The following guide is for an Inverted V | + | The following guide is for an Inverted V 66½' on each leg @ 45degrees for 75-meter |
band frequency inductor cap and ind select | band frequency inductor cap and ind select | ||
Revision as of 09:57, 2 March 2017
These are efficient antenna tuners capable of handling full legal limit power for use with amateur radio.
Inductor Guide
Inductor selection is a starting point for you to tune to resonance with your own antenna setup.
Dentron recommends setting both capacitor selectors (Transmitter Matching) and (Antenna matching) to setting 5 before trying to locate the correct inductor setting for the frequency. Watch for the highest noise/signal level on the S meter. When the best inductor is located then fine tune using the capacitance tuning dials.
The following guide is for an Inverted V 66½' on each leg @ 45degrees for 75-meter
band frequency inductor cap and ind select ----------------------------------------------------------- 160 1990 R 6.7, R, 5.0 80 3980 K 4.0, K, 3.0 1:1 60 40 20 15 10 -----------------------------------------------------------
