Difference between revisions of "Dentron MT-2000A and MT-3000A"
m |
m (→Inductor Guide) |
||
| Line 11: | Line 11: | ||
Inductor selection is a starting point for you to tune to resonance with your own antenna setup. | Inductor selection is a starting point for you to tune to resonance with your own antenna setup. | ||
| − | Dentron recommends setting both capacitor selectors (Transmitter Matching) and (Antenna matching) to setting 5 before trying to locate the correct inductor setting for the frequency. Watch for the highest noise/signal level on the S meter. When the best inductor is located then fine tune using the capacitance tuning dials. | + | Dentron recommends setting both capacitor selectors (Transmitter Matching) and (Antenna matching) to setting 5 before trying to locate the correct inductor setting for the frequency. Watch for the highest noise/signal level on the S meter. When the best inductor is located then fine tune using the capacitance tuning dials. If tuning for the higher bands 20, 15 and 10 set the "transmitter" capacitance to 8 instead of 5. |
(A) on the inductor is the highest frequency and (R) is the lowest frequency on the inductor switch. | (A) on the inductor is the highest frequency and (R) is the lowest frequency on the inductor switch. | ||
Revision as of 17:29, 2 March 2017
These are efficient antenna tuners capable of handling full legal limit power for use with amateur radio.
- Freq Coverage: 1.8 MHz - 30 MHz continuous
- Power Handle: 3000 watts P.E.P.
You should connect only one antenna at a time to the MT-2000A. The MT-3000A will accommodate multiple simultaneous connected antennas.
Although you can physically connect an antenna via the PL-239 and another antenna via the balanced line connector to the MT-2000A, you should not do this as there is no way to select between them from the unit and consequently you will have problems.
Inductor Guide
Inductor selection is a starting point for you to tune to resonance with your own antenna setup.
Dentron recommends setting both capacitor selectors (Transmitter Matching) and (Antenna matching) to setting 5 before trying to locate the correct inductor setting for the frequency. Watch for the highest noise/signal level on the S meter. When the best inductor is located then fine tune using the capacitance tuning dials. If tuning for the higher bands 20, 15 and 10 set the "transmitter" capacitance to 8 instead of 5.
(A) on the inductor is the highest frequency and (R) is the lowest frequency on the inductor switch.
The following guide is for an Inverted V 66½' on each leg @ 45degrees for 75-meter
band frequency inductor cap and ind select ----------------------------------------------------------- 160 1990 R 6.7, R, 5.0 80 3980 K 4.0, K, 3.0 1:1 60 40 20 15 10 -----------------------------------------------------------
