Difference between revisions of "Kenwood TS-830S"
From Free Knowledge Base- The DUCK Project: information for everyone
(→restoration checklist) |
|||
| Line 4: | Line 4: | ||
[[File:TS-830S_Checklist.gif|thumb|none|320px]]<BR><small><small>*some moron ham originally created this list, but offered it in such poor resolution as a JPG even though it was B&W I figured since anyone could be that stupid they do not deserve credit for its creation.</small></small> | [[File:TS-830S_Checklist.gif|thumb|none|320px]]<BR><small><small>*some moron ham originally created this list, but offered it in such poor resolution as a JPG even though it was B&W I figured since anyone could be that stupid they do not deserve credit for its creation.</small></small> | ||
| + | |||
| + | *Replace capacitors with new | ||
| + | *check final tubes for emission standards | ||
| + | *check driver tube | ||
| + | *clean and lubricate (with a Teflon based lube) shafts and mechanical parts | ||
| + | *clean the VFO shaft. Remove side panel off VFO and clean with contact cleaner. | ||
| + | *inspect for burnt resistors, check relays. | ||
Revision as of 12:40, 26 May 2017
Hybrid HF Transciver
restoration checklist
*some moron ham originally created this list, but offered it in such poor resolution as a JPG even though it was B&W I figured since anyone could be that stupid they do not deserve credit for its creation.
- Replace capacitors with new
- check final tubes for emission standards
- check driver tube
- clean and lubricate (with a Teflon based lube) shafts and mechanical parts
- clean the VFO shaft. Remove side panel off VFO and clean with contact cleaner.
- inspect for burnt resistors, check relays.
