Sonicview SV-4000 FTA Receiver

From Free Knowledge Base- The DUCK Project: information for everyone
Revision as of 10:20, 28 March 2008 by Admin (Talk | contribs)

Jump to: navigation, search

Flashing From USB Thumb Drive

  1. Save the bin file to your USB Thumb Drive
  2. Power on the Sonicview receiver
  3. Using the remote, press the MENU button
  4. Insert Thumb Drive in the front USB port
  5. Select INSTALLATION from the menu
  6. Scroll down and select USB MASS STORAGE as the source
  7. Press OK on the remote
  8. Now select the correct bin from the list (there may only be one)
  9. Press the RED button on the remote to start the flash process
  10. It is important that you DO NOT DISTURB the unit and wait patiently for the flash process to complete
  11. The receiver will reboot itself after a few minutes.

Dish Network Settings

  • ! YOU MUST BE A PAID SUBSCRIBER. NEVER PROGRAM FOR CHANNELS YOU ARE NOT PAYING FOR! IT IS ILLEGAL TO PIRATE SATELLITE TELEVISION!

Settings: 

LNB power          ON
LNB type           OCS-DP
LNB frequency      11250
Transponder        110=12224, 119=12239
22khz              OFF
Search option      All
Network search     ON
Diseqc             110=2, 119=1
Motor              Disable
Legacy switch      OFF

You have to set your antenna seting correctly for your dishpro twin OCS DP, diesq port 1 119, diesq port 2 110. Do not do blind scan on circular sats auto scan only.


FAQ

  • Q: Some channels are locked, namely, the adult content channels.
A: Go into parent control and unlock the xxxx channels. Go to system settings, parental control, enter 0000, unlock adult channels and switch ratings lock to not used.
  • Q: What are all the settings I should check to make sure nothing is locked out?
A: Go to menu, sistem settings, parentel control, enter "0000", and check if: receiver lock is "OFF", menu lock is "OFF", scramble lock is "OFF", adult channel lock is "OFF", rating lock is "NOT USED".
  • Q: I cant get anything in the EPG to show, the programming guide is basically blank. How do I get the EPG to work?
A: For Dish Network goto channel 239 and let it stay there for about two minutes. This works if you have the settings for 7-day EPG and Stand-By EPG set to ON. For Bell Satellite use channel 410. Another method is to turn the EPG Auto Update ON in the menu and then turn receiver off with the remote for 5 minutes and it will show full epg.
  • Q: My audio is fading out or gone, how do I get it back?
A: Go into the settings and turn off Dolby Sound.


 

 

Retrieved from "https://wiki.robotz.com/index.php?title=Sonicview_SV-4000_FTA_Receiver&oldid=2466"