Intel WEAP2011EU Access Point
- INTEL WEAP2011EU
- Product: WEAP2011EU
- Manufacturer: INTEL
- Description: INTEL AKA SYMBOL TECH 2.4GHZ 802.11B WIFI EARLY MODEL AP EURO MO
Intel® PRO/Wireless 2011 LAN Access Point
Functioning as a wireless hub, the Intel PRO/Wireless 2011 LAN Access Point serves as a bridge between an existing wired network and wireless devices. In addition, the access point can act as a repeater, passing along transmissions from one access point to another, creating a wireless backbone and connecting hard-to-reach areas. Intel wireless access points are simple to install, since they ship with a site survey tool to assist in proper placement for desired coverage and performance. IT administrators can manage and monitor the network of access points remotely via standard web browser.??Up to 11Mbps throughput provides reliable access to email, Internet, file sharing and other network resources. The Intel PRO/Wireless 2011 LAN Access Point always seeks to connect at 11Mbps and then switches to 5.5, 2 or 1, as network traffic demands, for increased signal range - up to 500 meters, for broad roaming capabilities.
Configuring
There is no reset button. This router may be access via a NULL MODEM serial cable.
The AP acts as a DTE device to connect directly to a DTE device with a null-modem serial cable. The direct serial access method requires a communication program with ANSI emulation.
The AP serial port is a DB-9 9-pin male connector. The serial port allows PPP connections to another AP, or a UI connection to a configuration PC. Connecting the AP directly to a PC with a DB 9-pin serial port requires a null modem cable.
The factory-configured AP accepts a direct serial connection to the UI.
- Enable serial port.
- Set Port Use to UI.
- Disable modem connection.
- 1. Attach a null modem serial cable from the AP to the terminal or PC serial port.
- 2. From the terminal, start the communication program such as HyperTerminal for windows.
- 3. Select the correct COM port along with the following parameters:
- 19200, 8, no parity, 1, no flow control
- 4. Press [ESCAPE]
Factory Reset
You have to bridge pins 2 and 3 on the db9 connector at the rear of the access point. After doing so, convert the last 6 digits of the serial number (in pairs) to hex. example, if your last six digits are 052161, the ip of the access point is 10.5.21.61. It always starts with 10 and the subnet mask is 255.255.0.0.
Support
