Talk:EnGenius EOC1650 Outdoor Wireless AP/Bridge

EOC-1650 FAQ (mirror)

EOC1650

Can I downgrade firmware safely with this product?

Yes

I cannot get into the device from my computer. What is the basic setting check?

- Make sure you are directly connected to the unit.

- Do not have a switch or router in between and do not connect wirelessly.

- Make sure your power injector/adapter is on, power is going to the unit and the “network” side is going to your computer.

- Make sure your computer is set to a static IP address of 192.168.1.10.

- Type in 192.168.1.1 using Internet Explorer

How far can I go using POE (Power over Ethernet)?

The device uses non standard injector voltage. Limit distances to 300 feet or less. Do not connect this unit to any 802.3af PoE switch!

How to change the IP Address?

The default IP address is 192.168.1.1. This IP address is typically in conflict with many routers out in the market. You will need to change the IP address manually to an IP address that is different but part of the same network. This means if your router IP address is 192.168.1.1, you should change the device to 192.168.1.2, for example. We recommend you change the IP address before other settings. You change your IP address in the “LAN” section in the GUI.

How to reset the device?

Locate the reset button next to the CAT5 (RJ45) connection. Press and hold the reset button for 10 seconds and then let go. You should see your 10/100 LAN connection at your computer go away and then come back. That will confirm a reset has occurred. The unit settings should all be back to default including its IP address of 192.168.1.1.

How to setup AP WDS Repeater?

Check here to download the setup instructions.

How to setup the device under Apple MAC OS X environment?

1. Go to "System Preferences" 2. In the "System Preferences" window, under the "Internet & Network" heading, click on "Network" 3. On the left side, select the network interface you wish to configure. Select a setting from the "Configure" drop-down menu 4. If configuring a static IP address, select "Manually" and then fill in the IP address and Subnet Mask fields, then click "Apply". If configuring to use a DHCP assigned IP address, select "Using DHCP" and then click "Apply"

How to setup WDS Bridge?

Check here to download the setup instructions.

What is considered a “good” signal?

The signal meter is not available in AP mode. In CB mode, under connection status, a signal of -74dbm or better is a good signal. It’s important to understand which direction numerically is a better signal. Dbm’s are referenced to 1 milliwatt. 1mW = 0dbm. A stronger signal would be a positive number and a weak signal would be a very negative number. For example, a -50dbm signal is stronger signal than -92dbm.

What is spanning tree protocol?

When there are several possible paths a packet can route to (redundant links for increased reliability for example), a loop can occur (jamming up the network). It is used to prevent these loops.

What is the default gateway?

The default gateway is your router’s IP address. The default gateway information is not required, but is recommended.

What is the default user name and password to log into this device?

Log in name is “admin” and password is “admin” by default.

What is WDS Mode?

Stands for Wireless Distribution System. Allows access points to link together and provide repeating. Note however, this repeating comes at a cost of reduced bandwidth. Bandwidth will be reduced by 30-40%, and it is recommended that NO multiple repeating hops be done for this reason.