The following lines were added (+) and removed (-):
Notice above where it says, "The TUNER-BYPASS SWITCH ONLY AFFECTS COAX CONNECTOR. It does not function on open wire or balanced connections." How can this be accurate when you look at the schematic? It looks to me like the balun is still a factor whether or not the bypass is engaged, however, the capacitors and inductor are still bypassed even when using balanced line. Notice above where it says, "The TUNER-BYPASS SWITCH ONLY AFFECTS COAX CONNECTOR. It does not function on open wire or balanced connections." How can this be accurate when you look at the schematic? It looks to me like the balun is still a factor whether or not the bypass is engaged, however, the capacitors and inductor are bypassed when using balanced line with the bypass engaged. ==references==The connection from S1A left to the so239 should have the line going to the center of the connector I believe.* [http://wireless-girl.com/Projects/Transmatches/DentronMT2000A.html Dentron MT-2000A Antenna Tuner]Also, it looks like the balun could be bypassed using balanced line if one side of the balanced line was connected to the Single Wire connector while the other side of the balanced line was jumpered (using a wire with alligator clips) to the chassis.==references==* http://bama.edebris.com/manuals/dentron/mt2000a/[[Category:Tangible Product]]