The following lines were added (+) and removed (-):
The General Setup is a wizard with several screens to click though. Just keep clicking the next button in the bottom right until you come to the "Remote Control" screen, which should be screen eight.The General Setup is a wizard with several screens to click though. You will skip past a few screens (typically 6) without altering the settings by simply clicking the "next" button in the lower right. You will skip past the following: Database Configuration 1/2, Database Configuration 2/2, Settings Access, General, Media Monitor, and Shutdown/Reboot Settings until you come to the screen labeled "Remote Control."[[File:mythmote04.jpg]][[File:mythmote04b.jpg]]Check the box labeled "Enable Network Remote Control Interface." Leave the default port set to "6546". Now click the next button in the bottom right and on the final screen click the finish button in the bottom right. Check the box labeled "Enable Network Remote Control Interface." Leave the default port set to "6546" and UDP "6948." Now click the next button in the bottom right and on the final screen click the finish button in the bottom right.