Changes

CPE Wifi Client Integrated Radio and Antenna Index

1,480 bytes added, 03:40, 22 October 2010
The following lines were added (+) and removed (-):
[[Image:motorolacanopy01.jpg]]=== Canopy Access Point (AP) ===The Access Point (AP) is a base station that can incorporate between one and twelve transceivers. Each transceiver operates with a 60-degree directional antenna to provide coverage to one sector. Each AP transceiver delivers up to 6.5 Mbps of data through put with connectivity to 200 subscribers. Systems with more than three access point transceivers should use an AP Installation Kit which includes an Ethernet switch, AC power supply, Global Positioning System (GPS) receiver with interconnect board; this receiver is used to synchronize the transmissions of all APs to minimize interference between APs. The AP operates with a Radio Frequency (RF) bit rate of 10 Mbps and has a range of approximately two or ten miles, depending on configuration. Each AP transceiver requires a 24-volt power source (included in AP installation kit) and provides a single 10BaseT/100BaseTX connection.== EnGenius Technologies, Inc. ===== EOC1650 ===[[EnGenius EOC1650 Outdoor Wireless AP/Bridge]] is a low cost, indoor / outdoor, 802.11g Outdoor 200mW Bridge / Access Point with Dual Antennas.  Equipped with an internal directional antenna and connection for an external antenna, includes an omnidirectional external antenna.  Power over Ethernet.  Multiple operation modes are Access Point / Client Bridge / Client Router with speed up to 54Mbps. Includes POE power injector for outdoor deployment.  [[Category:Radio]]
Bureaucrat, administrator
16,192
edits