Changes

CPE Wifi Client Integrated Radio and Antenna Index

954 bytes added, 15:11, 20 February 2008
The following lines were added (+) and removed (-):
[[Image:motorolacanopy01.jpg]]=== Canopy Access Point (AP) ===The Access Point (AP) is a base station that can incorporate between one and twelve transceivers. Each transceiver operates with a 60-degree directional antenna to provide coverage to one sector. Each AP transceiver delivers up to 6.5 Mbps of data through put with connectivity to 200 subscribers. Systems with more than three access point transceivers should use an AP Installation Kit which includes an Ethernet switch, AC power supply, Global Positioning System (GPS) receiver with interconnect board; this receiver is used to synchronize the transmissions of all APs to minimize interference between APs. The AP operates with a Radio Frequency (RF) bit rate of 10 Mbps and has a range of approximately two or ten miles, depending on configuration. Each AP transceiver requires a 24-volt power source (included in AP installation kit) and provides a single 10BaseT/100BaseTX connection.
Bureaucrat, administrator
16,192
edits