The following lines were added (+) and removed (-):
*Unloaded - Caliper*'''Unloaded''' - Caliper, typically all parts are individual. This is the most common situation.IMPORTANT: Remove cap from brake fluid reservoir to relieve pressure on caliper. If you don't do this you won't be able to separate the compressed caliper, especially if it is stuck! === preventing a stuck brake caliper ===One way to keep your brake calipers from sticking is to give them a good spray with brake cleaner. There are times when road dirt, brake dust, and other particles will get into the calipers causing them to "gum" up and stick. Brake cleaner will help penetrate into the calipers and loosen them up.* '''caliper slides''': those two pins that screw ends that hold the caliper on your disc. They can get gummed up and stick, preventing fee caliper movement. Never use petrolium based grease on these caliper slides. Use silicone based caliper slide grease. * caliper piston: if the caliper slides aren't causing the caliper to stick, then it is probably the piston. It is the part in the center that pushes the pad when break fluid pressure builds against it.* ''note that other factors besides caliper slides and piston can cause a caliper to stick, such as a pinched or collapsed break line.''=== remove caliper ===# Car jacked, wheel unlocked (so steering wheel turns), tire removed.# Position drain pan under caliper. # remove bottom caliper slide bolt. rotate caliper up, do additional testing to verify caliper is bad.# remove brake pads. They will fall out easily since they are held in place by tension only. don't lose metal guide clips.# loosen top caliper slide bolt. Slide caliper off, now caliper is free of disc completely.# Locate the "banjo" bolt (connects caliper to the brake hose). Loosen it. (this is how you disconnect brake line.)# pull out banjo bolt. it is hollow. the brake line banjo fitting will now fall away from the caliper.# there are two steel or copper washers, one on each side of the banjo fitting. Don't lose them.# you will lose a lot of fluid out of the brake line banjo fitting. if you can plug it temporary you will save fluid.