The following lines were added (+) and removed (-):
Transponder - 12268 LNB Type .......... OSC-DP Transponder Freq - 11250 LNB Frequency ..... 11250 LNB Type - OCS-DP 22KHz ............. OFF 22Khz - Off Transponder ....... 12239 * DiSEqC Number - LNB1 DiSEqC ............ Port 1 Legacy SW - None Motorized - None=== EchoStar 8,10 (110W) === LNB Type .......... OSC-DP=== EchoStar 6,8 (110W) === LNB Frequency ..... 11250 Transponder - 12224 22KHz ............. OFF Transponder Freq - 11250 Transponder ....... 12224 * LNB Type - OCS-DP DiSEqC ............ Port 2 22Khz - Off DiSEqC Number - LNB2 Legacy SW - None Motorized - None=== Two LNB One Cable === 110: port 2 (for dish 500) Set the Diseqc the EchoStar 6,8 to Port 2 110: port 2 (for dish 500) Set the Diseqc the EchoStar 8,10 to Port 2 61.5: port 3 === Testing the Configuration ===There are several Transponders active on a satellite. The nice thing about using 12239 as the default setting for ES7 and 12224 for ES8/10 is that it will help you to ensure you have the LNB settings in the correct order, as well as the antenna pointed correctly. Transponder 12224 will not have any signal quality on ES7. If it does, you probably have them backwards (technically this would be an aiming issue that would result in only achieving signal from 1 of the 2 satellites.)