The following lines were added (+) and removed (-):
[[File:showIcom7600.jpg]]==Operating=====Memory Channel===SAVE:#Set the desired frequency, operating mode and filter width in VFO mode.#From root press [MEMORY](F4) to display memories #Select channel # using up and down arrow keys or set#Push and hold [MW] for 1 sec. to program the displayed frequency, operating modeDELETE:#Select memory mode with [VFO/MEMO].#Push [MEMORY] (F-4) to select memory list screen.#Select the desired memory channel with the up and down arow keys#Push and hold [CLR] (F-5) for 1 sec. to clear the contents.SELECT:*Besides using the up and down arrow keys to scroll though the channels in memo mode you can go direct to channel*IN MEMO mode press [F-INP] and enter number, then press either the up or down arrow goes directly to channel number*press [EXIT/SET], [F-4], and hold [F-1] Roll and turn VFO to scroll though list on LCD, press [F-3] select to go to channel SET -> OTHERS -> CI-V Baud Rate 9600 SET -> OTHERS -> CI-V Address 7Ah SET -> OTHERS -> Transceive ON SET -> OTHERS -> Output (fot ANT) OFF SET -> OTHERS -> USB Serial Function Decode SET -> OTHERS -> Decide Baud Rate 19200 USB Serial Function should be "Decode" and not "CI-V" if using rigcat![[Image:fldigi-ic7600-460x340.jpg]] ==Technical==Microphone pinout wiring guide.<BR>[[File:IcomIC7600microphonepinout.png]]<BR>Caution: Do not short pin 2 to ground as this can damage the internal 8 volt regulator. DC voltage is applied to pin 1 for microphone operation. Use caution when using a non-Icom microphone.