The following lines were added (+) and removed (-):
There is no reset button. This router may be access via a serial cable.There is no reset button. This router may be access via a NULL MODEM serial cable. The AP acts as a DTE device to connect directly to a DTE device with a null-modem serial cable. The direct serial access method requires a communication program with ANSI emulation. The AP serial port is a DB-9 9-pin male connector. The serial port allows PPP connections to another AP, or a UI connection to a configuration PC. Connecting the AP directly to a PC with a DB 9-pin serial port requires a null modem cable. The factory-configured AP accepts a direct serial connection to the UI. *Enable serial port. *Set Port Use to UI. *Disable modem connection. :1. Attach a null modem serial cable from the AP to the terminal or PC serial port. :2. From the terminal, start the communication program such as HyperTerminal for windows. :3. Select the correct COM port along with the following parameters:* 19200, 8, no parity, 1, no flow control:4. Press [ESCAPE] Select COM port and configure to:* 19200, 8, no parity, 1, hardware flow control== Support ==* http://support.intel.com/support/wireless/wlan/pro2011/accesspoint/sb/cs-022039.htm