The following lines were added (+) and removed (-):
===Power on/off===Once power is connected, press the button to turnthe transceiver on. Three ascending tones will sound,indicating that the transceiver has correctly poweredon. Hold the key for 2 seconds to turn thetransceiver off.===Turn Volume===Press “VOL+” to raise the volume. Press “VOL-” tolower the volume. Hold the key to go fast. The volumeis adjusted in 15 steps from 0 (lowest) to 15 (highest).The default setting is 4.===Select Channel===You can select an operating channel in one of severalways:#Use the programming software to store operating channels ahead of time. You can then access them directly in MR mode, using the channel up/down buttons or the numeric keypad on the microphone.#Input frequency values by using the numeric keypad in VFO mode.#Press the “CHA+” or “CHA-” key to select the frequency in VFO mode. Hold the key to go fast#Input channel number by using the numeric keypad to select memory channel in MR mode. Note: This transceiver has a dual-watch function, you can switch between A and B channels using the “C” key (A/B switch key) on the microphone keypad. The A channel can only operate in MR/CH mode, while the B channel can be set to either MR/CH or VFO mode. Please refer to page 40-41 regarding the user-defined key function of the A/B switch and the VFO/MR switch.In VFO mode, the transceiver will store the most recently used frequency in each of its supported ranges. To switch quickly between the transceiver’s supported frequency ranges, press the key.==Menu=====Power on/off===Once power is connected, press the button to turnthe transceiver on. Three ascending tones will sound,indicating that the transceiver has correctly poweredon. Hold the key for 2 seconds to turn thetransceiver off.===Turn Volume===Press “VOL+” to raise the volume. Press “VOL-” tolower the volume. Hold the key to go fast. The volumeis adjusted in 15 steps from 0 (lowest) to 15 (highest).The default setting is 4.===Select Channel===You can select an operating channel in one of severalways:#Use the programming software to store operating channels ahead of time. You can then access them directly in MR mode, using the channel up/down buttons or the numeric keypad on the microphone.#Input frequency values by using the numeric keypad in VFO mode.#Press the “CHA+” or “CHA-” key to select the frequency in VFO mode. Hold the key to go fast#Input channel number by using the numeric keypad to select memory channel in MR mode. Note: This transceiver has a dual-watch function, you can switch between A and B channels using the “C” key (A/B switch key) on the microphone keypad. The A channel can only operate in MR/CH mode, while the B channel can be set to either MR/CH or VFO mode. Please refer to page 40-41 regarding the user-defined key function of the A/B switch and the VFO/MR switch.In VFO mode, the transceiver will store the most recently used frequency in each of its supported ranges. To switch quickly between the transceiver’s supported frequency ranges, press the key.