The following lines were added (+) and removed (-):
The next 2m VHF section could be added for a dual band configuration. The tuning is impacted by omitting sections as it has to do with loading and any additional length added by metal in the isolator. It might be desirable to operate at times with only one or two sections to prevent damage to the antenna where there might be trees or conditions hazardous to the antenna. This is a bit of a top heavy antenna that is not going to take much abuse from trees or excessive forces. Folding it down is fine except you cannot operate while it is folded down. Removing the top allows limited operation in the most critical bands.In the two section dual band configuration the 70cm resonance tend to go back to a lower frequency better suited for ham operation rather than GMRS operation. This is desirable for true dual band ham use. The VHF side then becomes the portion of antenna slightly too short for optimal resonance on 2m ham. This can be corrected by a simple lengthening of the second, or in this case, top segment. The correct length can be obtained within the distance permitted and with the setscrew tightened the antenna is correctly tuned for true dual band 2m / 70cm ham operation.This antenna works great as a dual band 2m/70cm antenna. With the entire antenna assembled 10-meter operation is acceptable but not stellar. Without going through extensive testing it seemed difficult to tune for 50Mhz operation. Further testing for 50Mhz is required to determine the antenna performance on this band.[[Category:HAM Radio]][[Category:Ham Radio]]