The following lines were added (+) and removed (-):
To use WPA the NAS package must be installed. ipkg install nas nvram set wl0_auth_mode="" was wl0_auth_mode=open nvram set wl0_akm=psk was wl0_akm=none nvram set wl0_crypto=aes+tkip was wl0_crypto=tkip nvram set wl0_auth=0 was wl0_auth=0 nvram set wl0_wpa_psk=yoursecretp was wl0_wpa_psk=""''(replace yoursecretp with a password of your choice, I used something with letters, numbers, and symbols)'' nvram commitNote: I chose to use PSK instead of PSK2 because PSK2 is not supported on my WinXP laptop OOB without updating something (probably wifi related driver).The startup script for NAS has to be modified for our interface configuration. It defaults to br0, but with our setup our wifi is on br1. vi /etc/init.d/S41wpaReplace all references to br0 with br1. There should be two references.Line 7: brctl show 2>&- | grep "${real_ifname}" >&- 2>&- && ifname=br1line 86: [ "$ifname" = "br1" ] && exitWhen the NAS service is running, doing a ps ax should show the process: /usr/sbin/nas -P /var/run/nas.lan.pid -l br1 -H 34954 -i eth2 -A -m 4 -k yoursecretp -s icarus -w 6 -g 360