The following lines were added (+) and removed (-):
IRQ stands for Interrupt ReQuest and refers to special numbered channels that are used by devices to get the processors attention. This is how information to and from your PCI card get handled by the system processor.== XP: Standard PC with C-Step i486 ==When XP is first installed it tries to determine what type of BIOS is available on the computer. Newer systems have what is known as Advanced Configuration and Power Interface (ACPI) capability. If you press F5 just as the blue setup screen appears, you will see a menu allowing you to choose: Standard PC with C-Step i486 OtherOn some less commmon motherboards this menu is triggered without having to press F5 because the Windows setup program could not determine if the BIOS is ACPI capable.Once you drop the CD in the tray and fire up the computer to install XP, the first thing you'll see at the bottom of the screen is the option to press F6 if you need to install a SCSI or RAID controller. Don't press F6. Press F5 instead. This will take you to a separate menu of Hardware Abstraction Layer's where you can choose an appropriate HAL that supports ACPI.Using F7 to disable ACPI: There are situations where it is definitely not desirable to use an ACPI HAL even if it is supported by the BIOS. This predominately applies to servers, but to ensure that an ACPI HAL will not be used or automatically detected and used, press F7 instead of F5. If you press F7, the Standard PC HAL loads and the ACPI compliance check is bypassed.Using F5 to disable ACPI: This technique has been verified to work in our testing on a modern Intel Core 2 compatible motherboard. Using F5 to interrupt the install as described above, then selecting "Standard PC with C-Step i486" caused Windows XP to install without ACPI support.[http://support.microsoft.com/kb/299340 How to force a Hardware Abstraction Layer during an upgrade or an installation of Windows XP] <BR>Article ID: 299340To determine if your computer was detected as being ACPI enabled:#Right click My Computer then click Properties > Hardware > Device Manager.#Expand the entry called Computer. #If the entry is 'Advanced Configuration and Power Interface (ACPI) PC' you're all set. If it says 'Standard PC' the computer BIOS was not detected as being ACPI capable.The ACPI cannot be changed after installation. If you try, you will corrupt your installation.== It is now safe to turn off your computer. ==Remember this message from the early Windows 95 days? It is still present in Windows XP for uses that have purposely disabled ACPI during the Windows XP installation, or for installations that failed to install ACPI support. It is unlikely that a modern post Pentium 4 motherboard does not support ACPI.To have Windows XP automatically power down the computer when you choose to shut down Windows, you will need to ensure that ACPI support is installed during the Windows XP installation. It cannot be added later.Many users report this condition when installing Windows XP on a newer laptop computer. The laptop computer's type of BIOS was unclear to the Windows XP installer. Reinstall Windows XP and use the F5 technqiue mentioned above to manually select the ACPI type. You may have to manually load a driver, from a floppy disk, provided by the laptop manufacturer.If you intentionally set out to disable ACPI support during the Windows XP installation, this is one indicator that you were successful. Your computer did not automatically power off when you quit Windows.[[Category:Windows]]