The following lines were added (+) and removed (-):
==attenuator==There are two attenuator modes in your scanner. Normal attenuator mode allows you to set the attenuator on a per-channel basis. Normal mode is useful when individual channels are found to be prone to interference. Global attenuator mode applies attenuation to every channel in the scanner, and overrides any normal mode attenuator.To assign attenuation to a channel in the scanner, press ATT when the scanner is stopped on a channel, or manually navigate to a channel. A appears on the top of the display. Press ATT again to turn attenuation off.To assign attenuation to a search bank, press ATT while searching. Attenuation will be applied to the active search bank, or search group within a search bank. Press ATT again to turn attenuation off.==receive mode==The scanner defaults to the commonly used AM or FM/Digital receive mode for each frequency range. The preset mode is correct in most cases. To change the receive mode, repeatedly press MODE. AM configures an AM channel. FM/DIGITAL configures an FM/Digital channel. CT configures a CTCSS channel. DC configures a DCS channel. MO configures a MO channel for analog or digital Motorola trunking system channels, or APCO-25 trunking system channels. ED configures an ED channel for EDACS trunking system channels.MO and ED modes are not available when performing servicesearches, limit searches and the TUNE function.