Changes

Talk:2009 Jeep Wrangler JK

0 bytes added, 21:56, 25 August 2020
/* How do you reset the TPMS on a Jeep JK? */
The following lines were added (+) and removed (-):
    For about 10 minutes, drive at or above 50 mph. The next time you restart your car, it’s likely the sensor will reset.*  For about 10 minutes, drive at or above 50 mph. The next time you restart your car, it’s likely the sensor will reset.    Turn the key to the “On” position, but don’t start the car. Locate the TPMS reset button under the steering wheel and press in, holding until the tire pressure light blinks three times. Start the car and wait 20 minutes for the sensor to refresh.*  Turn the key to the “On” position, but don’t start the car. Locate the TPMS reset button under the steering wheel and press in, holding until the tire pressure light blinks three times. Start the car and wait 20 minutes for the sensor to refresh.    Inflate all tires to 3 PSI over their recommended amount, then deflate them completely. Be sure to include the spare tire, as it may have a sensor as well. Once they’re all deflated, re-inflate to the recommended tire pressure.*  Inflate all tires to 3 PSI over their recommended amount, then deflate them completely. Be sure to include the spare tire, as it may have a sensor as well. Once they’re all deflated, re-inflate to the recommended tire pressure.    With the vehicle off, use a wrench to disconnect the positive battery cable. Turn the car on and honk the horn for about three seconds. This will discharge any power still stored in the vehicle. Then reconnect the battery.*  With the vehicle off, use a wrench to disconnect the positive battery cable. Turn the car on and honk the horn for about three seconds. This will discharge any power still stored in the vehicle. Then reconnect the battery.
Administrator
652
edits