The following lines were added (+) and removed (-):
The Yaesu FT-7800R dual bander operates on 2 meters and 70 centimeters. High power output is featured with 50 watts on 2 meters and 40 watts on 430 MHz. CTCSS/DCS Encode/Decode is built in.==Programming and Operation=====Memory Storage===#Select frequency in the VFO mode. Be sure set up any desired CTCSS or DCS tones, as well as offset. The power level may be also be set.#Press and hold in the [ V/M ( MW )] key for 1/2 second. A memory number will appear (blinking) on the display.#Within ten seconds of pressing the [ V/M ( MW )] key, use DIAL knob or microphone [ UP ] / [ DWN ] buttons to select a memory channel for storage.#To attach an alpha/numeric name "Tag" to the memory, press and hold in the [ V/M ( MW )] key for 1/2 second, then proceed to the next step; otherwise press the [ V/M ( MW )] key to save.===Repeater Shift===144 MHz shift will be 600 kHz, 70 cm, the shift is 5 MHz. ARS = Automatic Repeater Shift. ARS Feature ON/OFF - hold in the [ BAND ( SET )] key and rotate the DIAL knob to select Menu #4 (ARS). Press the [ BAND ( SET )] key momentarily, then rotate the DIAL knob to enable or disable. Press the [ BAND ( SET )] key momentarily to save the new setting.Manual Repeater Shift - #Press and hold in the [ BAND ( SET )] key for 1/2 second to enter the Set mode.#Rotate the DIAL knob to select Menu #33 (RPT.MOD).#Press the [ BAND ( SET )] key momentarily, then rotate the DIAL knob to select the desired shift among "RPT.–," "RPT.+," and "RPT.OFF."#Press the [ BAND ( SET )] key momentarily to save the new setting, then press and hold in the [ BAND ( SET )] key for 1/2 second to exit to normal peration.Default Repeater Shifts - hold in the [ BAND ( SET )] key, DIAL knob to select Menu #39 (SHIFT), [ BAND ( SET )] key and rotate the DIAL knob. Then [ BAND ( SET )] key momentarily to save.