Difference between revisions of "Radio Shack Pro-136 Scanning Receiver"
From Free Knowledge Base- The DUCK Project: information for everyone
(Created page with "==Frequency Coverage== *25.0000-27.9950 (in 5 kHz steps) *28.0000-54.0000 (in 5 kHz steps) *59.7500, 65,7500, 71.7500, 81.7500, 87.7500 (in 6 MHz steps) *88.000-107.900 (In 10...") |
(No difference)
|
Revision as of 09:28, 16 December 2023
Frequency Coverage
- 25.0000-27.9950 (in 5 kHz steps)
- 28.0000-54.0000 (in 5 kHz steps)
- 59.7500, 65,7500, 71.7500, 81.7500, 87.7500 (in 6 MHz steps)
- 88.000-107.900 (In 100 kHz steps)
- 108.0000-136.9875 (in 12.5 kHz steps)
- 137.0000-174.0000 (in 5 kHz steps)
- 179.7500, 185.7500, 191.7500, 197.7500, 203.7500, 209.7500, 215.7500
(in 6 MHz steps)
- 380.0000-399.9875 (in 12.5 kHz steps)
- 400.0000-512.0000 (in 6.25 kHz steps)
Resetting Procedure
This procedure clears all the information you have stored in the scanner. Before you reset the scanner, try turning it off and on again to see if it begins working properly. Reset the scanner only when you are sure it is not working properly.
- Unplug the AC adapter and remove the batteries from the scanner.
- While holding down 2, 9 and PSE, plug the AC adapter back into the scanner. CLEAr appears for about 2 seconds as the scanner clears its memory.
Note: Do not turn off the scanner again until CLEAr disappears. Otherwise, the scanner might not clear its memory properly
