Difference between revisions of "Telephone RJ11 Wiring Reference"

Revision as of 21:18, 13 June 2011

RJ-11 Plug Wiring

The RJ-11 connector has six terminals on it. Typically, only the middle 4 are used. Line 1 is the center pair, red and green. More recently Cat5 cable is being used. In that case, the blue pairs are for the first line and use the orange pairs for the second line.

Traditional Telephony to Cat 5 Cross Reference

Table:

White with Blue 	Green 	Tip
Blue with White 	Red 	Ring
White with Orange 	Black 	Tip
Orange with White 	Yellow 	Ring

How to punch down an RJ11 Jack

RJ-11 is the standard for most telephones, answering machines and fax machines used in North America.

Go about an inch or more in and strip the telephone wire. Now use the string inside with the wire pairs to pull back, cutting further into the wire, exposing more. Cut off the wire right at where you applied the wire stripper. When you strip telephone or Ethernet wire the wire strippers often damage the small fragile wire. it is best to use the string to pull back, exposing more wire, and then cutting them off where the stripper was applied. It creates some waste, but it ensures you have no compromised wire. Now trim away the excess insulation which has been cut by pulling back the string and left hanging.

If using Ethernet cable, look for the blue pair. The blue pair is the first pair to use.

If using

Apply the blue and the blue white into the RJ-11 block. It is good to keep a twist present right up to where the cable goes into the block. The two center pins on the RJ11 will be used for a single line telephone.