Memorex MK1800 FRS Base Station

From Free Knowledge Base- The DUCK Project: information for everyone
Revision as of 14:06, 25 August 2015 by Admin (Talk | contribs)

Jump to: navigation, search
  • 14 Channel Selection
  • Transmits and Receives Signals up to 2 -Mile Range
  • External Microphone/ Earphone Jack
  • Uses 4 "AA" Batteries (Not Included)
  • DC Jack for AC Power Connection- Includes AC Adaptor

Instructions

Mk1800frs01.png

  1. Antenna
  2. CHANNEL/VOLUME Up/Down Buttons
  3. Transmit Indicator
  4. Display
  5. Battery Compartment (Bottom of Unit)
  6. POWER Button
  7. MIC/EARPHONE Jack (Side of Unit)
  8. MENU Button
  9. TALK Button
  10. CALL Button
  11. MIC (Microphone)
  12. AUTO Button
  13. MONITOR Button
  14. Power/VOX Indicator
  15. ENTER/LOCK Button
  16. DC6V Jack

BATTERY INSTALLATION

Open the battery compartment and insert four (4) "AA" size batteries. Put the battery compartment cover back into place. When the battery is low, the display will show "L" and blink.

DC JACK

To use this unit with the provided AC adapter having 6V and a positive center pin, insert the AC adapter’s plug into the DC6V jack on the unit and the other end into an AC outlet. The batteries will be disconnected when the AC adapter is connected.

OPERATION

To turn on: Press and hold the power button for 1 second; the unit will beep and the Power/VOX indicator will light green.

To turn off: Press and hold the power button for 1 second; the unit will beep and the Power/VOX indicator will turn off.

If there are no transmissions for 2 seconds, the unit will automatically switch to standby mode (display will turn off), which will save batteries (if used). When a transmission is received or if you attempt to send a transmission, the display will turn back on.

For best results rotate the antenna to 90 degrees so that it is vertical or 180 degrees if the unit is mounted to a wall.

To adjust the volume: press the Channel/Volume Up or Down button until the desired level (1 - 16) appears on the display.

To select a channel: press the Menu button once and the display will blink. You have 7 seconds to change the channel. Press the Channel/Volume Up or Down until the desired channel is displayed. Press the Enter/Lock button when done.

To set the beep:

To transmit:

To monitor:

To send a Call Tone:

Retrieved from "http://wiki.robotz.com/index.php?title=Memorex_MK1800_FRS_Base_Station&oldid=11822"