Taotao DB17 125cc Dirt Bike

From Free Knowledge Base- The DUCK Project: information for everyone
Revision as of 19:11, 14 June 2019 by Ke0etz (Talk | contribs)

Jump to: navigation, search

Specifications

Engine

Engine Type:4 Stroke, Single Cylinder Displacement:125cc Ignition:CDI Starter:Kick Start Cooling:Air Cooled

Drive Train

Transmission:4-speed (1-N-2-3-4) Manual Clutch Drive System:Chain

Chassis / Suspension / Brakes

Front Brake:Hydraulic Disc --- Hand Braker Rear Brake:Hydraulic Disc --- Foot Braker Front Tire:70/100 - 17 Rear Tire:90/100 - 14

Dimensions / Capacities

Length:70 inches Width:30 inches Height:43 inches Wheelbase:49.2 inches Seat Height:30.70 inches Ground Clearance:13.0 inches Net Weight:154 lbs Gross Weight:200 lbs Fuel Capacity:1.5 gal

Maintenance

Oil

Two locations, engine and transmission (gear box).

  • Engine - recommended to use oil with moly additive (Liqui Moly) Use 10w-40.
  • Transmission / Gearbox - you can use 80wt motorcycle transmission fluid.

Comes new with oil in it. Verify oil at correct level. Run first time for five minutes, shut off and then change the oil prior to continued operation.

If you run the engine prior to oil change it may make it easier to drain the oil as the liquid drains well when hot. However, use caution because this can also present the risk of burns. Watch out! Don't drain hot oil directly onto skin.

There are a couple drain plugs, one for the motor and one for the gearbox. When replacing motor oil also replace the oil filter. The engine oil plug is down by the magneto / stator. Some mechanics say it is not necessary to replace the filter each change, perhaps every other, that's up to you.

Remove the oil filter slowly and observe the spring that will fly out if you are not paying attention. You'll have to keep it clean and place it back into place when you install the new filter.

Add oil quantity according to operating manual, do not overfill.

Chain

The chain should have some slack however if it is too lose you will have failure.

Use silicon based lubricant and spray into front of chain, turn wheel to coat entire chain. Don't use an oil lubricant as it will collect dirt. There are some wax based lubricants as well.

This bike has a tensioner on the underside of the chain which may make chain tension seem tight compared to other bikes you might be used to.

Motor

The new bike has the valves adjusted closed. You will have to make adjustment to specification in the owner manual.

Resources

Here are a few links for assembly info and oil change info for the Dirtbike.