Difference between revisions of "2009 Jeep Wrangler JK"
From Free Knowledge Base- The DUCK Project: information for everyone
m |
|||
| Line 23: | Line 23: | ||
* Turn off and remove the key. You should hear a confirmation tone. | * Turn off and remove the key. You should hear a confirmation tone. | ||
| − | + | Disable security alarm | |
| + | * It might be possible to disable the security alarm by the removal of a specific fuse. This will also likely disable the keyless entry option. | ||
Revision as of 14:31, 16 December 2016
- MPG: Up to 15 city / 20 highway
- Towing capacity: 1,000 to 3,500 lbs
- Engine: 3.8 L V6
- Horsepower: 202 hp
- Other model years: 2007, 2008, 2010, 2011
Disable seat-belt alarm
- Turn the ignition switch to the OFF position, and buckle the driver’s seat belt.
- Turn the ignition key to the ACCESSORY/RUN position (engine does not need to be running), and wait for the Seat Belt Warning Light to turn off.
- Within 60 seconds of starting the vehicle, unbuckle and then re-buckle the driver’s seat belt at least three times within 10 seconds, ending with the seat belt buckled.
- Turn the ignition key to the OFF position. A single chime will sound to signify that you have successfully completed the programming.
The Enhanced Warning System (BeltAlert) can be reactivated by repeating this procedure.
The important steps are:
- DO NOT START THE JEEP.
- Get in
- Buckle-up
- Turn the key to ACC on.
- Once the seat belt dummy light goes out, unbuckle and buckle 3 or more times.
- Turn off and remove the key. You should hear a confirmation tone.
Disable security alarm
- It might be possible to disable the security alarm by the removal of a specific fuse. This will also likely disable the keyless entry option.
