Difference between revisions of "Baofeng UV-B6"

Revision as of 17:55, 22 November 2015

programming

save simplex channel to memory

This model programs channel different than the BF-F8HP/UV-5R because the channel memory is not accessed though the [MENU] button.

Enter and Save to channel

1. key in desired frequency such as 442.400 for example
2. Press and hold [VM/SCAN] until voice says MEMORY CHANNEL and/or channel number flashing
3. Select desired channel number with up/down and press [AB/ENTER] to save to memory

NOTE: If channel number is blinking, that channel has been previously programmed and will be overridden.

repeater offset and CTCSS

In this example will enter a 70cm repeater with PL and +5Mhz offset.

offset + or -

1. Enter the VFO Mode
2. Set offset [MENU] and arrow to item 21 (SFTP)
3. Press [AB/ENTER] use arrow to select + and press [AB/ENTER] and [MENU], [MENU] to save

offset amount

1. Press [MENU] and arrow to item 22 (OFFSET)
2. Press [AB/ENTER] then enter the offset
3. Press [AB/ENTER] and [MENU], [MENU] to save

PL / CTCSS

1. Press [MENU] and arrow to item 12 (TCODE)
2. Press [AB/ENTER] then enter the frequency in Hz
3. Press [AB/ENTER] and [MENU], [MENU] to save

Enter and Save to channel

1. key in desired frequency such as 442.400 for example
2. Press and hold [VM/SCAN] until voice says MEMORY CHANNEL and/or channel number flashing
3. Select desired channel number with up/down and press [AB/ENTER] to save to memory

NOTE: If channel number is blinking, that channel has been previously programmed and will be overridden.

External Resources

• [1]