Difference between revisions of "Baofeng UV-B6"
From Free Knowledge Base- The DUCK Project: information for everyone
(→External Resources) |
|||
Line 32: | Line 32: | ||
#Select desired channel number with up/down and press [AB/ENTER] to save to memory | #Select desired channel number with up/down and press [AB/ENTER] to save to memory | ||
NOTE: If channel number is blinking, that channel has been previously programmed and will be overridden. | NOTE: If channel number is blinking, that channel has been previously programmed and will be overridden. | ||
+ | |||
+ | ==Technical Support== | ||
+ | ===Firmware Update=== | ||
+ | The firmware in these radios cannot be updated. The microcontroller is an OTP type. (One Time Programmable) Once 'flash' programmed at the factory, it cannot be changed. | ||
+ | |||
== External Resources == | == External Resources == |
Revision as of 17:59, 22 November 2015
Contents
programming
save simplex channel to memory
This model programs channel different than the BF-F8HP/UV-5R because the channel memory is not accessed though the [MENU] button.
Enter and Save to channel
- key in desired frequency such as 442.400 for example
- Press and hold [VM/SCAN] until voice says MEMORY CHANNEL and/or channel number flashing
- Select desired channel number with up/down and press [AB/ENTER] to save to memory
NOTE: If channel number is blinking, that channel has been previously programmed and will be overridden.
repeater offset and CTCSS
In this example will enter a 70cm repeater with PL and +5Mhz offset.
offset + or -
- Enter the VFO Mode
- Set offset [MENU] and arrow to item 21 (SFTP)
- Press [AB/ENTER] use arrow to select + and press [AB/ENTER] and [MENU], [MENU] to save
offset amount
- Press [MENU] and arrow to item 22 (OFFSET)
- Press [AB/ENTER] then enter the offset
- Press [AB/ENTER] and [MENU], [MENU] to save
PL / CTCSS
- Press [MENU] and arrow to item 12 (TCODE)
- Press [AB/ENTER] then enter the frequency in Hz
- Press [AB/ENTER] and [MENU], [MENU] to save
Enter and Save to channel
- key in desired frequency such as 442.400 for example
- Press and hold [VM/SCAN] until voice says MEMORY CHANNEL and/or channel number flashing
- Select desired channel number with up/down and press [AB/ENTER] to save to memory
NOTE: If channel number is blinking, that channel has been previously programmed and will be overridden.
Technical Support
Firmware Update
The firmware in these radios cannot be updated. The microcontroller is an OTP type. (One Time Programmable) Once 'flash' programmed at the factory, it cannot be changed.
External Resources
- [Miklor Programming Baofeng UV-B6 http://www.miklor.com/UVB5/UVB5-ProgMem.php]