Baofeng UV-B6
programming
repeater offset and CTCSS
In this example will enter a 70cm repeater with PL and +5Mhz offset.
offset + or -
- Enter the VFO Mode
- Set offset [MENU] and arrow to item 21 (SFTP)
- Press [AB/ENTER] use arrow to select + and press [AB/ENTER] and [MENU], [MENU] to save
offset amount
- Press [MENU] and arrow to item 22 (OFFSET)
- Press [AB/ENTER] then enter the offset - Press [AB/ENTER] and [MENU], [MENU] to save
Enter 'TCODE' (CTCSS / DCS)
- Press [MENU] , then (channel knob) to Menu 12 (TCODE) - Press then [MENU] to select CTCSS / DCS / OFF - Press (channel knob) to select desired code. - Press to save. - Press [MENU] or any key to exit.
- Enter Frequency
- Using the keypad, enter he desired frequency. - Press & Hold the [VM/SCAN] button to display channels 01-99 - Press (channel knob) to select the desired channel.
NOTE: If channel number is blinking, that channel has been previously programmed and will be overridden.
- Press to save.
Enter the MR Mode
- Press [VM/SCAN] to enter MR (channel mode).