Difference between revisions of "Baofeng UV-B6"
From Free Knowledge Base- The DUCK Project: information for everyone
(→programming) |
(→programming) |
||
Line 1: | Line 1: | ||
==programming== | ==programming== | ||
+ | ===save simplex channel to memory=== | ||
+ | This model programs channel different than the BF-F8HP/UV-5R because the channel memory is not accessed though the [MENU] button. | ||
+ | |||
+ | Enter and Save to channel | ||
+ | #key in desired frequency such as 442.400 for example | ||
+ | #Press and hold [VM/SCAN] until voice says MEMORY CHANNEL and/or channel number flashing | ||
+ | #Select desired channel number with up/down and press [AB/ENTER] to save to memory | ||
+ | NOTE: If channel number is blinking, that channel has been previously programmed and will be overridden. | ||
+ | |||
===repeater offset and CTCSS=== | ===repeater offset and CTCSS=== | ||
In this example will enter a 70cm repeater with PL and +5Mhz offset. | In this example will enter a 70cm repeater with PL and +5Mhz offset. |
Revision as of 17:55, 22 November 2015
Contents
programming
save simplex channel to memory
This model programs channel different than the BF-F8HP/UV-5R because the channel memory is not accessed though the [MENU] button.
Enter and Save to channel
- key in desired frequency such as 442.400 for example
- Press and hold [VM/SCAN] until voice says MEMORY CHANNEL and/or channel number flashing
- Select desired channel number with up/down and press [AB/ENTER] to save to memory
NOTE: If channel number is blinking, that channel has been previously programmed and will be overridden.
repeater offset and CTCSS
In this example will enter a 70cm repeater with PL and +5Mhz offset.
offset + or -
- Enter the VFO Mode
- Set offset [MENU] and arrow to item 21 (SFTP)
- Press [AB/ENTER] use arrow to select + and press [AB/ENTER] and [MENU], [MENU] to save
offset amount
- Press [MENU] and arrow to item 22 (OFFSET)
- Press [AB/ENTER] then enter the offset
- Press [AB/ENTER] and [MENU], [MENU] to save
PL / CTCSS
- Press [MENU] and arrow to item 12 (TCODE)
- Press [AB/ENTER] then enter the frequency in Hz
- Press [AB/ENTER] and [MENU], [MENU] to save
Enter and Save to channel
- key in desired frequency such as 442.400 for example
- Press and hold [VM/SCAN] until voice says MEMORY CHANNEL and/or channel number flashing
- Select desired channel number with up/down and press [AB/ENTER] to save to memory
NOTE: If channel number is blinking, that channel has been previously programmed and will be overridden.