The following lines were added (+) and removed (-):
=== Operation ===To turn trimmer on, pull the lock out button back and, then squeeze the trigger switch. To turnthe tool off, release the trigger. Slowly swing trimmer side-to-sideTo convert for maintenance edging, turn off the tool. Holding the trimmer with one hand by theauxiliary handle, grasp the collar and push in direction of arrow and rotate the trimmer head until it stops, (halfturn), release your hand, (rotate clockwise when viewed from the switch end). The tool is locked in the edgerposition. Rotate the wire edge guide forward and down into place before edging.Return to trimming position by turning the tool off, push in direction of arrow and rotating the trimmer headcounter clockwise until it stops. When using the tool in the trimmer mode you may choose to fold the wire edgeguide up out of the way.=== Line Feed ===Your trimmer uses .065” (1.65mm) diameter nylon line to cut grass and weeds quickly and easily. In time, the tip ofthe nylon line will become worn and the auto feed mechanism will automatically feed and trim a fresh length of line.The cutting line will wear faster if the cutting is done along sidewalks or other abrasive surfaces or heavier weedsare being cut. The automatic feed mechanism senses when more cutting line is needed and feeds and trims thecorrect length of line whenever it is required. You don’t even have to think about it. Do not bump unit on ground inattempt to feed line or for any other purpose.