The following lines were added (+) and removed (-):
[[File:blackanddeckergrasshog720x340.jpg]]=== Spool Replace and Line Issues ===From time to time, especially when cutting thick or stalky weeds, the line feeding hub may become clogged with sapor other material and the line will become jammed as a result.To resolve a jam turn off the trimmer and remove the battery.# Press the release tabs on the line spool cover and remove the cover by pulling it straight off.# Lift the spool of nylon line out of the hub and clear any broken line or cutting debris from the spool area.3In case of jams and tangled line unwrap about one foot (30cm) of line to ensure that it is undamaged. If it is OKrewind it and insert the line end through the eyelet in the spool hub. Pull the line through thehole to maintain tension while placing the spool down into the hub with the notched side exposed.# Press the spool down GENTLY and rotate it until you feel it drop into place. (When in place, the spool will turn afew degrees left and right freely.)# Snap the spool cover back on, insert the battery and turn the tool on. In a few seconds or less you’ll hear the nylonline being cut automatically to the proper length.Bulk line for your trimmer/edger is available at extra cost from your local dealer or Black & Decker Service Center.To install bulk line, turn off the trimmer and remove the battery.# Press the release tabs on the line spool cover, and remove the cover by pulling it straight off.# Remove the spool from the tool and remove and discard all line on the spool.# Insert one end of the bulk line into the hole in the spool about 1/2” (12mm).# Hold the line in the hole and pull the rest of the line through the slot in the spool.# Snugly and evenly wind the bulk line onto the spool in the direction of the arrow on spool until it is nearly full. (The spool holds 50 ft. (15.2m) of line and bulk line is sold in 50 foot sections.)# Insert the line end through the eyelet in the spool hub. Pull the line through the hole to maintain tension while placing the spool down into the hub with the notched side exposed.# Press the spool down GENTLY and rotate it until you feel it drop into place. (When in place, the spool will turn a few degrees left and right freely.)# Snap the spool cover back on, insert the battery and turn the tool on. In a few seconds or less you’ll hear the nylon line being cut automatically to the proper length.[[File:blackdeckerinstalline.png]]== Parts and ServiceBlack and Decker NST2018 Type 1 18 Volt 12" Cordless GRASSHOG Trimmer / Edger Parts[[File:blackanddeckertrimmerparts.png]] [[Category:Outdoor Power Equipment]][[Category:Lawn and Garden]][[Category:Tangible Product]]