The following lines were added (+) and removed (-):
The buttons on the top of the radio are as follows: [ F ] [V/M] [REV] [ 0 ] function vfo or mem reverse power on/offThe buttons on the front face below the LCD are dual function [CALL] [MHz ] [MONI] or or or [F] + TONE XMIT POWER SQUELCH* Press [F] and [CALL]. The secondary function is TONE. Repeat to toggle through transmit tone, receive tone squelch, and DCS. Land on the one you want to set, once set, press [VM] to save.* Press [F] and [CALL]. The secondary function is TONE. Repeat to toggle through transmit tone, receive tone squelch, and DCS. Use the big dial to set tone, you cannot enter with pad. Land on the one you want to set, once set, press [VM] to save.* +/-/none: This is tricky and doesn't work the way the manual describes.* +/-/none: This is tricky and doesn't work the way the manual describes. You press hold down [MHZ] until it beeps and shows the offset frequency, then you press and hold down [MHZ] again for another long press until it beeps. Each additional long press will toggle between + - or none, however, nothing on the display indicates the current mode. You have to use trial and error. Just toggle the state once and save by pressing [VM] then test to see what state you ended up with. Rinse and repeat until you have the offset or lack of offset you desire. SAVE TO CHANNEL MEMORY* Press [F] and turn dial to empty channel number, then press [VM] to save to that location. If the channel is empty the number will blink with no symbol below it, if the channel is occupied a black arrow will appear below the flashing number.* Unlike some radios, you WILL SAVE OVER a channel memory that is occupied. DELETE CHANNEL MEMORY* In channel mode turn dial to select channel to delete and press [F], release, and press [REV]. You will be prompted with "SURE?" you then press [REV] again to erase channel memory for that one channel. [[Category:Electronics]][[Category:Radio]][[Category:Ham Radio]][[Category:2-Way Radio]][[Category:Tangible Product]]