Difference between revisions of "Yaesu FT-7800R"

From Free Knowledge Base- The DUCK Project: information for everyone
Jump to: navigation, search
m (CTCSS Operation)
m
Line 1: Line 1:
 +
===Repeater Shift===
 +
144 MHz shift will be 600 kHz, 70 cm, the shift is  5 MHz.  ARS = Automatic Repeater Shift. 
 +
 +
ARS Feature ON/OFF - hold in the [ BAND ( SET )] key and rotate the DIAL knob to select Menu #4 (ARS).  Press the [ BAND ( SET )] key momentarily, then rotate the DIAL knob to enable or disable.  Press the [ BAND ( SET )] key momentarily to save the new setting.
 +
 +
Manual Repeater Shift -
 +
#Press and hold in the [ BAND ( SET )] key for 1/2 second to enter the Set mode.
 +
#Rotate the DIAL knob to select Menu #33 (RPT.MOD).
 +
#Press the [ BAND ( SET )] key momentarily, then rotate the DIAL knob to select the desired shift among "RPT.–," "RPT.+," and "RPT.OFF."
 +
#Press the [ BAND ( SET )] key momentarily to save the new setting, then press and hold in the [ BAND ( SET )] key for 1/2 second to exit to normal peration.
 +
 +
 
===CTCSS Operation===
 
===CTCSS Operation===
 
CTCSS setup involves two actions: setting the Tone Mode and then setting of the
 
CTCSS setup involves two actions: setting the Tone Mode and then setting of the

Revision as of 22:11, 19 November 2017

Repeater Shift

144 MHz shift will be 600 kHz, 70 cm, the shift is 5 MHz. ARS = Automatic Repeater Shift.

ARS Feature ON/OFF - hold in the [ BAND ( SET )] key and rotate the DIAL knob to select Menu #4 (ARS). Press the [ BAND ( SET )] key momentarily, then rotate the DIAL knob to enable or disable. Press the [ BAND ( SET )] key momentarily to save the new setting.

Manual Repeater Shift -

  1. Press and hold in the [ BAND ( SET )] key for 1/2 second to enter the Set mode.
  2. Rotate the DIAL knob to select Menu #33 (RPT.MOD).
  3. Press the [ BAND ( SET )] key momentarily, then rotate the DIAL knob to select the desired shift among "RPT.–," "RPT.+," and "RPT.OFF."
  4. Press the [ BAND ( SET )] key momentarily to save the new setting, then press and hold in the [ BAND ( SET )] key for 1/2 second to exit to normal peration.


CTCSS Operation

CTCSS setup involves two actions: setting the Tone Mode and then setting of the Tone Frequency. These actions are set up by using the [TONE(REV)] key and Set mode #44 (TN FRQ).

  1. Press the [ TONE ( REV )] key several times, so that "ENC" appears on the display
  2. press and hold in the [ BAND ( SET )] key for 1/2 second to enter the Set mode, then rotate the DIAL knob to select Menu #44 (TN FRQ). This Menu selection allows setting of the CTCSS tone frequency. Press the [ BAND ( SET )] key momentarily to enable adjustment of the CTCSS frequency. Rotate the DIAL knob.